Handreader Enrollment Process 

From the handreader idle prompt

  

  Press the Clear and Enter button

 

The screen should now look like this

 

 Press the number 4 and then press Enter.

 

The screen should now look like this

 

 Select Yes to add an employee or select No to move to the next menu option

 

Adding an Employee

 After selecting Yes to add an employee you should see this screen.

 

Enter the number that the employee will use each time to identify him/her at the handreader and press Enter. The enrollment process will then begin.

The screen should now look like this

 

Have the employee place their hand on the platen with their palm flat and their fingers touching the finger pegs, once the reader is able to take a measurement, it will prompt the employee to remove their hand

 

The employee will be prompted to place and remove their hand 2 more times to get an average of the measurements taken, upon successful enrollment the screen will look like this

 

 The enrollment is now complete for this employee and you will now be back to the Add Employee screen; press the Yes # key to enroll another employee or the Clear button to leave the enrollment screen.

 

Adding a Supervisor

 

Once you have added your employees, it’s a good idea to add a couple of supervisors to the reader, these individuals will be responsible for adding and removing employees and once added, restrict regular employees from going into the system menus and changing settings or removing employees.

At the Add Employee screen press No

 

you should now be at the Add Supervisor screen

 

use the same steps used to add a supervisor as you did to add an employee, when you are finished adding supervisors, press the clear button at the add supervisor screen to go to the main menu.

Once supervisors are enrolled, only a supervisor can gain access to the reader setup and enrollment menus.

  

Supervisor Access to Reader

 From the handreader idle prompt

 

 

 

 Press the Clear and Enter button

 

The screen should now look like this

  

 Enter your supervisor number and press Enter, you will be prompted to scan your hand once, now the screen will ask you for the desired password.